Step Two - Resetting Up

Now it was time to set the tank back up.

First I put the filters back on. Then the heater. Then the hood.

Then I started filling.

Then I put in the water conditioner.

I decided to put in cold water. I figured with the 90+ degree heat this would be the most cost effective way to get the tank where I want it temperature wise.

I then put the air line back into the tank. I forgot about it. Not that it mattered - The water line was still not above the tube's bottom.

I then put the thermometer back in. The reading was 60 degrees straight out of the tap.

And now it is full.

I turned on the filter (without media), heater, and air pump.

Next is to let the tank cycle, which is step three.